View Revisions: Issue #2262

Summary 0002262: Add bulk callsign lookup in Logbook
Revision 2018-04-25 22:16 by WA9PIE
Steps To Reproduce Here's a use-case scenario:

User has some number of QSOs in the log where the worked station's fields have not been populated from the callsign lookup sources.
- User selects some number of QSOs in the log
- Right-click menu shows "Callsign Lookup" (see attached image below)
- Logbook sends each QSO out to the callsign lookup selections (same logic currently used when a single QSO is logged) and brings back data for that call... fills the fields as it would if it were a new QSO... then moves to the next selected QSO... repeats until all selected QSOs have completed.

This should probably run as a background process (in other words... not tie-up Logbook while this is happening).
Revision 2017-09-22 23:19 by WA9PIE
Steps To Reproduce Here's a use-case scenario:

User has some number of QSOs in the log where the worked station's fields have not been populated from the callsign lookup sources.
- User selects some number of QSOs in the log
- Right-click menu shows "Callsign Lookup"
- Logbook sends each QSO out to the callsign lookup selections (same logic currently used when a single QSO is logged) and brings back data for that call... fills the fields as it would if it were a new QSO... then moves to the next selected QSO... repeats until all selected QSOs have completed.